

Wind speed bearing cartridge

Wind speed bearing cartridge for anemometers that were manufactured from 2013 onwards.
Due to an evolution of this part of the Davis anemometers (ref. 6410), the bearings can no longer be changed directly. This spare part is therefore a replacement for the bearings. This modification was made at the beginning of 2018. Consequently, stations purchased later are affected.
Based on 9
reviews
-
I replaced the cartridge with this new one and my anemometer has come back to life. (Translated review)
-
.
-
Good product. (Translated review)
-
Nickel (Translated review)
-
I haven't installed the product yet, but it's exactly what I ordered. (Translated review)
-
Perfect piece (Translated review)
-
American equipment, the wrench used to remove the rotating part does not comply with European standards, so you have to make your own to remove it, which is a bit of a hassle! (Translated review)
-
Not used yet because I have already changed the bearings, I will replace them at the first sign of wear. The product looks tight and easy to install. (Translated review)
-
short (Translated review)
You might also like


Vantage Pro Vane Anemometer
10 other products in the same category:

Electronic card for shelters with 24 hours...

Thermo-Hygrometer Sensor for Vantage Pro 2...

Vantage Pro 2 wind vane spoiler (old...

Base and tilting bucket for Vantage Pro2...

Power Assembly for Rain Collector Heater

Anti-moisture foam for ISS Vantage Pro 2

SIM card for Vantage pro 2 wireless ISS...

Mounting base for Anemometer 7911 (Vantage...

Complete Replacement Kit Vantage Pro2
