Temp/Hum datalogger with display (external sensors)

€274.00 (tax incl.) (€228.33 VAT excl.)

The HOBO® UX100-023 Temperature and Relative Humidity datalogger uses an external sensor to record temperature and relative humidity in closed environments.

Reference

UX100-023

Preorder

Description

The HOBO® UX100-023 logger allows recording temperature and relative humidity (with an accuracy of 2.5%) indoors with its external sensors. Using the HOBOWare® software, it is easy to set high or low alarms for the recording campaigns. It is also possible to set up bursts of measurements (faster interval) depending on certain conditions.

The device also allows the calculation of certain statistics (minimum, maximum, average or standard deviation). The small LCD screen incorporated in the device allows the temperature, the campaign status, the battery level and the memory used between two discharges to be displayed.

Data sheet

Miscellaneous

Power supply: 1 x 3 V CR2032 lithium battery
Size: 3.66 x 8.48 x 2.29 cm
Weight: 30g
Power supply autonomy: 1 year, with recording interval of 1 minute and sampling interval of more than 15 seconds
Operating temperature: Recording: -20° to 70°C; Reading: 0 to 50°C
Protection: IP50
Interface: USB
Display: visible: 0° to 50°C (32° to 122°F), the LCD may react slowly or not display anything if the temperature is outside this range.
Memory: 128 KB (84 650 measurements, maximum)
Recording interval: 1 second to 18 hours, 12 minutes, 15 seconds

Temperature

Measure: Temperature
Resolution: 0.024°C at 25°C
Accuracy: ±0.21°C from 0° to 50°C
Measuring range: -20°C to 70°C
Length: cable 1.83 m
Drift: less than 0.1°C per year
Response time: 6 minutes in air at 1 m/s

Humidity

Measure: Humidity
Resolution: 0.05%
Accuracy: ±2.5% at 10 to 90% relative humidity typical to a maximum of 3.5% including hysteresis at 25°C (77°F), ±5% at less than 10 and more than 90% relative humidity
Measuring range: 1 to 100%
Drift: less than 1% per year
Response time: 5 minutes at 90% in air 1 m/s